The product is color enhancing tile sealer, for interior and exterior use. Suitable for slate, natural stone, tumbled marble, travertine, terracotta, quarry, terrazzo and sandstone. Provides enhanced honed finish. For use on wall and floor surfaces. Strongly protects against water, oil grease and dirt. Allows surface to breathe.
There is also available LTP Color Intensifier 1 L
LTP Color Intensifier Benefits
Color intensifier without “just washed” look
Designed for wet spaces (bathroom, saunas etc.)
Allows surface to breathe
Suitable for interior and exterior use
Directions for use:
The surface to be treated must be completely clean, dry and free from contamination. If necessary, first clean floor with LTP Grimex and allow to dry thoroughly. Apply this sealer thinly and uniformly with a cloth, brush or sponge and allow to penetrate for approximately 15- 30 minutes before wiping over with a clean dry fluff-free cloth to remove all and any excess which may remain on the surface.
Important note: The surface must retain a natural finish after treatment. Any excess left on the surface could oxidize to form an unsightly gloss varnish. For stronger color enhancement and in the case of more absorbent surfaces, further coats may be applied. Allow at least 30-60 minutes from application of previous coat before applying further coat. This product will dry after about two hours, but will take a further three days to become fully resistant. Do not apply in direct sunlight or in a temperature exceeding 25˚C. Beware of application upon floors with under floor heating as the product may dry prematurely. If you are unsure of correct application methods, test on an inconspicuous area, prior to general application.
Use only in well ventilated areas. Do not breathe vapours.
Approximately 5-10 sqm per litre depending on substrate porosity.
Routinely sweep the floor and wash with LTP Waxwash. Clean walls and work surfaces with LTP Stonewash spray. For further information, refer to the technical data sheet.