Profesional quality, fireproof, cement-based white colored powder made with synthetic resins. Applicable in thin layers, this non-toxic product with increased adherence can be used for interior and exterior walls and floors. It helps to quickly install the tiles without deteriorating the material (does not leave stains).
Surface preparation: The supporting surface must be clean, undeformed, dry and stable and the applied pieces must not present traces of grease, oils, dust or other impurities. The concrete must be at the age of maturity, the screeds must be at least 28 days old and groutings must have low absorption levels.
Preparation and application methods: Continuously pour a bag in 6.5 liters of water and mix manually or mechanically using an electric mixer until an unitary paste is obtained. Mix once again after taking a break of about 5 minutes.
The resulting mortar must be spread on the supporting surface by using a channeled trowel. In the case of larger sized tiles, the product must also be applied on the surface of the stone. The tiles must be manually installed until a plane surface is obtained. Be careful to apply the tiles during the adhesive's open time limit.
Recommendations:
Do not wet the tiles before cladding.
Use the right amount of water while mixing.
Application temperature: between +5°C º- +30°C.
Direct sunlight and during bad weather (rain, snow etc.) is strictly forbidden during installation.
Usage properties:
Waiting time after mixing: 5 minutes
Time for installation: 2-3 hours since preparing the paste
Crust formation time: 20 minutes
Adjusting time: 15 minutes after applying it on the support
The tiles become practicable after 24
These times are valid for a temperature of 20 degrees C and a relative air humidity of 65%. Higher temperature values shorten these times, while lower ones increase them.
Contains cement. Makes an alkaline reaction with water. In case of eye contact, rinse with plenty of water and ask the doctor’s advice.
Technical data:
Adherence by traction: >0 5 N/sqmm
Adherence after water: >0 5 N/sqmm
Adherence after frost-defrost cycles: >0 5 N/sqmm
Extended open time (after 30 mintues): >0 5 N/sqmm
Slip: < 0 5 mm
Term of validity:
12 months from the date of manufacture if stored on wooden panels in a dry environment.
Consumption:
Interior: 3,5 sqm / sack
Exterior: 3 sqm / sack
