A powerful sealant, which provides an intensified honed finish to natural stone surfaces (slate, marble, travertine, terracotta, limestone, terrazzo etc.). It protects the material against water, grease stains and dirt. This product allows the surface of the stone to “breathe”. Quickly shipped through carrier with payment at delivery.
Benefits of the LTP COLOR INTENSIFIER
Intensifies the color of pale natural materials without having a ''wet look'' ;
Especially made for humi areas (bathrooms, saunas etc.)
Allows the treated surface to 'breathe'
Suitable for both interior and exterior works
A premium product designed for both professionals and non-professionals, LTP Color Intensifier is a powerful sealant which brings back to life any pale natural stone surface, regardless of its finishing style: honed, tumbled, brushed, unpolished etc – all these procedures will give the material a pale appearance. Especially used in humid spaces, the product offers great protection against water, stains, oils etc. all while allowing the treated surface to'breathe'. The product is suitable for travertine, granite, slate, marble, concrete, terrazzo or even brick.
Directions for use:
The surface to be treated must be completely clean, dry and free from contamination. If necessary, first clean floor with LTP Grimex and allow to dry thoroughly. Apply this sealer thinly and uniformly with a cloth, brush or sponge and allow to penetrate for approximately 15-30 minutes before wiping over with a clean dry fluff-free cloth to remove all and any excess which may remain on the surface
Please note: The surface must retain a natural finish after treatment. Any excess left on the surface could oxidise to form an unsightly gloss varnish. For stronger colour enhancement and in the case of more absorbent surfaces, further coats may be applied. Allow at least 30-60 minutes from application of previous coat before applying further coat. This product will dry after about two hours, but will take a further three days to become fully resistant. Do not apply in direct sunlight or in a temperature exceeding 25˚C. Use only in well-ventilated areas. Beware of application upon floors with under floor heating as the product may dry prematurely. If you are unsure of correct application methods, test on an inconspicuous area, prior to general application.
Approximately 5-10 sqm / liter depending on the porosity of the surface
Routinely sweep the floor and wash with LTP Waxwash. Clean walls and work surfaces with LTP Stonewash spray. For further information, refer to the technical data sheet.