Use for grouting natural and artificial stones (reconstructed), with various water absorption level, regular and irregular shapes and joints width 5-50 mm, interior and exterior. This product is also suitable for Nevada glass blocks and Clinker façade.
Benefits:
1. Durability against cracking
2. Compatible with natural stone treatments
3. Interior and exterior use
4. Suitable for 5-50 cm joints
5. Durable against water and abrasion
6. Will not alter tile color
7. Special decorative effect
Ingredients: grouting mortar available as powder, based on cement, with mineral additives and synthetic resins. It has abrasion resistance and it is easy to apply and clean.
Available colors: BEIGE
Packaging: 20 kg paper sacks, 1080 kg pallet (54 sacks).
Underlay preparation: joints have to be dust free and wiped from dry adhesive mortar. Grout joint is applied after minimum 24 hours since installation.
Preparation and usage: pour the content of 1 sack in approximately 4 L of cold water and use an electric mixer for mixing until homogenous, no lumps. Time-out for 5 minutes, then mix again. The obtained mortar is applied directly on joint network with margin trowel (for joints). Excess material is wiped with trowel and wet sponge. After 15-30 minutes it is diagonally wash with wet sponge over the joint section. Be very careful because joints must remain closed and smooth. Depending on your underlay (or stone type), repeat washing as needed or clean the surfaces with a soft hand brush.
Suggestions: It is recommended for bathroom, kitchen, living room, bedroom, terraces, walkways, fences, home bases. Installation within temperature range + 5 to + 30 °C; bad weather (rain, snow, strong wind, direct exposure to sunlight) should be avoided. Grouted joints should be protected from freeze and the already mentioned bad weather conditions for 24 hours. You can use the surfaces after 24 hours. Tools should be washed immediately with water after use.
