We present a premium sealant created for professional use. This product can easily and successfully replace acrylic varnishes. LTP Glaze Protector is a surface sealant (once applied, it forms a micro-film with a “freshly cleaned” aspect, extremely resistant to wear and stains), which can be used on all natural stone surfaces. The product does not require maintenance. It protects and enhances the surface. Quickly shipped with payment at delivery.
The benefits of LTP GLAZE PROTECTOR
Resistant to high traffic, low maintenance
Extra resistant to stains and wear
Created for interior spaces
Ensures a ''freshly cleaned look''
Perfect for pale materials (slate, limestone etc.)
Directions for use:
Newly installed surfaces – ensure surface to be treated is completely clean, dry and free from cement and grout stain (see LTP Grout Stain Remover).
Existing surfaces – first clean and degrease surfaces with LTP Grimex taking care to rinse well. Leave to dry out thoroughly (24 hrs). Any retained moisture in the grout joints may cause the LTP Glaze Protector to dry opaque or prevent the seal from reaching full hardness.
Interior only use (not for wet rooms or for shower cabins)
Apply using a J cloth saturated with the solution. Pour contents into a separate container. Dip cloth into the solution and wring out. Fold the cloth and apply evenly to the surface without rubbing. Apply until an evenly thin film is created (Avg. 3 times). Allow to dry (1 hr). For a glossier finish further coats should be applied at right angles to the first (max.6).
Do not over apply as too many coats may cause unsightly build up and/or reduce the efficiency of the product. Hardens after about an hour but will take a further three days to achieve full hardness and become fully water resistant. If in doubt, experiment on spare tiles to establish the correct method of application and optimum number of coats before general use. Avoid extremes of temperature. Do not apply on to rubber floors.
Routinely sweep the floor. Use LTP Floorshine to clean and protect treated surfaces. In areas where the seal becomes worn, apply more LTP Glaze Protector. At some stage, complete renovation of the seal may be desired. In this case use LTP Grimex to strip the original seal before re-sealing. Avoid using strong detergents to wash surfaces treated with LTP Glaze Protector.
1L = 30-40 sqm per liter (one layer) depending on the porousness of the underlayer.
Keep away from children. Store it in a frost-free area. Avoid extreme temperatures. Avoid using powerful solutions for cleaning the surfaces treated with LTP Glaze Protector.